W Audio Zenith 2K5 Amplifier

Code: AMP11
  • £349.00
Awaiting Stock | Next Day Delivery | Collect in store

The Zenith amplifier range from W Audio has been designed and engineered to work in any demanding installation or touring environment with military endurance. 


Oversized multi-speed fans and large heat sinks will keep the output stage cool even under the most extreme conditions. Service and maintenance is easy as the internal architecture is laid out for easy access by qualified technicians. Made with a heavy gauge welded steel chassis with vibration proof fittings and an emphasis on over engineering guarantees years of trouble free service in demanding environments. 


Many amplifiers distort with both channels loaded and driven before they hit full output power. Even some expensive "brand" name amplifiers will do this when presented with multiple drivers at low impedance (inductive load). The dirty signal makes it sound loud, but it will reduce speaker life. The Zenith amplifiers are designed to handle low impedance and inductive loads and when driven to excessive levels will "soft clip". The switchable limiter system is controlled by a high speed VCA chip that will limit both PEAK and RMS power to prevent clipping of the output stages.

Stereo output @ 2 Ohms: 1250W x 2

Stereo output @ 4 Ohms:   900W x 2

Stereo output @ 8 Ohms:   540W x 2

Bridge output @ 4 Ohms: 2500W

Bridge output @ 8 Ohms: 1800W

Frequency response: 20Hz - 25kHz

Signal to noise ratio: 107dB

Input connectors: Balanced XLR

Output connectors: Neutrik speakon and binding post

Protection: DC and thernal overload

Fan cooled

Ground lift

Indicators: Power, signal, active and clip

Low cut filter

Filters/coss over: High pass and low pass

Other features: Full range line out, Stereo, parallel and bridge, circuit breaker protection and heavy duty welded steel chassis

Power supply: 240V

Dimensions: 483 x 496 x 89mm

Weight: 23kg

This product has not been reviewed yet.